RubberB VS. Everest Watch Strap

[enjoythemusic]

Originally Posted by No SUBctitute

I'm hesitant to mess with the appearance of the strap. After sandpapering, when you put the strap on the watch, is the part of the strap that was sandpapered visible? If so, what does the sandpapered part look like? What grit sandpaper would you advise using?

i don't see anything after lightly sanding it down. just do a slight bit at the top edges of each strap so it does not put high pressure on the bezel.

jmho and of course ymmv. worked fine for me and is very easy.

[No SUBctitute]

Originally Posted by enjoythemusic

i don't see anything after lightly sanding it down. just do a slight bit at the top edges of each strap so it does not put high pressure on the bezel.

jmho and of course ymmv. worked fine for me and is very easy.

Okay. I will give it a go. Do you recall if you had to sand the entire width of the strap, or just the sides, or just the center?